Output Configuration

The Output Configuration section is where you can set up your outputs from StudioPro. These can be SDI, NDI, audio signals or all of the above. 

To get to the Output Configuration section, click the darkcog.PNG icon to open up the settings window. 

Settings.png

Click the Output tab. 

Output.png

That takes you straight to the Output Configuration section. 

Output configuration.png

This main section allows you to choose which Video and Audio you'd like to send. The Program, Preview and Multiview AV cannot be changed but you can configure where and how you send them, as you can for the other 8 available outputs. 

Click in the blank space by Video Device to open up the output settings for that particular output. 

Video Device.png

 

In the Device dropdown menu, you will see all available hardware outputs. This example is a QuickLink StudioPro410-8. Select the output you wish to use. 

Device.png

Mode allows you to select from available resolutions and frame rates. This will depend on your settings in Video. 

Mode.png

The Output Audio Device is where you select how you want to send your audio. Bear in mind that audio will be sent over SDI as standard so, you won't need to select the same Decklink output as in your Device dropdown again in the Output Audio Device dropdown. If you do, you may duplicate the signal. 

Output Audio Device.png

You also have the ability to output over NDI should you wish. Just tick the box to enable it and then give it a name.

NDI.png

Once you're happy you have your Output Settings configured just how you'd like them, click OK. 

OK.png

To actually send out your signal, click Start on the output you wish to send. 

Start.png

Once you're done, simply press Stop.png.

Was this article helpful?
1 out of 1 found this helpful
Share it, if you like it.